TYPE
"A" and TYPE "B". This refers to a minor detail on
the ends of the raised areas that are added to
strengthen panels. On the type B the large one is
more rounded at the end. They are hard to see on
the car as once the floors were originally
installed there was a tar-like sound deadening
marterial put on the metal. Otherwise riding in the
car would be similar to being in a metal
drum. As
the Type B is more expensive; we were selling both
Types of Floor Patch Pairs. Now there are only
rights so we are selling either two matching pieces
or one Type A and one Type B. This will continue
until our supply of the less expensive rights is
gone. RIGHT
- #741-02A FLOOR
PATCHES, REAR (Under Seat) 65-70,
1500 1600 2000 These
pieces are about 35" by 25 SEAT
REINFORCING STRIPS Seat
reinforcement strips are used on the rear floor pieces to
help spread out the load of the 4 seat studs that go through
the floor. They are 25 1/8 inch by 2 3/4 inch.
Datsun Roadster Floor
Pans Rallye Enterprises, Ltd.
This
is for the area where you normally put your feet,
the panel measures approximately 20" x
20". You can match the raised and depressed
areas to your floor to see exactly what it
replaces
SPL311 SRL311 FLOOR
PATCH PANELS Rallye
Enterprises,
Ltd.